CAME VER KIT Uživatelský manuál stáhnout pdf (Strana 26)

Micon Car Kit, Ver. 5.1Body Assembly Manual (Version for RX62T)

3.5.6. Finishing the Main Board

Note: Holes will be drilled later to accommodate the flathead screws. If the edges are filed down too far,

this could open up some of the inner holes, making it impossible to secure them using flathead

screws and weakening the strength of the board.

1 mm

File down the edge shown in photo 3.64 a little at a time. Eventually, the grooves (arrow) should be about 1 mm

wide, as shown in photo 3.65. Do the same on the other side.

Filing down the edges indicated by the dotted lines until

no grooves remain could end up opening up some of the

inner holes, which would reduce the strength of the

board. Therefore, file until grooves about 1 mm wide

remain.

File down the sides other than those indicated by the

dotted lines in photo 3.63 until no grooves remain.

Photo 3.63

Photo 3.64

Photo 3.65 Photo 3.66

File flat the edges indicated by the dotted lines in photo

3.66 to complete the task.

Groove width: approx. 1 mm

Figure 3.2 (Side View of Groove)

Main board

File until grooves about 1 mm

wide remain.

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 91 92

Žádné komentáře

CAME VER KIT Uživatelský manuál Strana 26