CAME VER KIT Uživatelský manuál stáhnout pdf (Strana 36)

Micon Car Kit, Ver. 5.1Body Assembly Manual (Version for RX62T)

Photo 5.13

Photo 5.14

As shown in photo 5.13, place the front shaft support

plate with the side having a narrow edge (the cut

side) on the left and the side having a wide edge on

the right. Then insert black screws into the holes

indicated by ovals in the photo.

Spring washers

Photo 5.15

Once the nuts are tightened and the assembly appears

as shown in photo 5.15, the task is complete.

Confirm that the arms can move up and down at the

oints secured by nylon nuts. If the movement is not

free, move the parts (arms) indicated by dotted lines

in photo 5.15 slightly outward.

The sensor arms still cannot move, loosen the nylon

nuts slightly to allow them to move freely.

Nylon nuts

Wide edge

Narrow edge

Underside Top

Turn over the assembly as shown in photo 5.14. Place

spring washers over the ends of the screws indicated

by arrows and then screw on and tighten nuts over

them.

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 91 92

Žádné komentáře

CAME VER KIT Uživatelský manuál Strana 36