CAME VER KIT Uživatelský manuál stáhnout pdf (Strana 80)

Micon Car Kit, Ver. 5.1Body Assembly Manual (Version for RX62T)

10.3. Mounting the Servo

Photo 10.23 Photo 10.24

In this section we will mount the servo on the body of

the micon car. Prepare the parts shown in photo 10.23:

 Servo front reinforcing plate

 2 servo back reinforcing plates

 2 screw and washer assemblies

(dia. 3 × 12 mm, washer dia. 6 mm)

 4 screw and washer assemblies

(dia. 3 × 15 mm, washer dia. 8 mm)

 4 nuts, 4 flat washers

Photo 10.25 Photo 10.26

Remove the studs that were partially tightened earlier

(photo 10.9).

Servo back reinforcing

Screw in screw and washer assemblies (dia. 3 × 12

mm, washer dia. 6 mm) at the locations indicted by

arrows in photo 10.27.

Photo 10.27 Photo 10.28

As shown in photo 10.24, fit the servo motor into

the opening in the servo support plate.

Position the servo back reinforcing plates as shown in

photo 10.26.

Partially tightened stud

Turn over the micon car body in order to insert screw

and washer assemblies (dia. 3 × 15 mm, washer dia. 8

mm) in the locations indicated by ovals in photo 10.28.

1 2 ... 75 76 77 78 79 80 81 82 83 84 85 ... 91 92

Žádné komentáře

CAME VER KIT Uživatelský manuál Strana 80